Chris-Craft 34 Tri-Cabin Enclosed Bridge Classic Cruiser

The engine was rebuilt in 2013 according to the owner. In September 2014 a mechanical survey found it to have good compression in all cylinders.

Batteries:
- Engine Starting Bank: (2) 12V Group 27 in a covered polyethylene battery box.
- House Bank: (4) Trojan 6V golf cart batteries located in a covered plywood battery box.

Fuel consumption and speed data shown is approximate and derived from industry information for this engine and boat model.

12 batterie volts, 6 batterie(s) chargé(s) par: moteur, prise de quai

This classic Chris Craft is built using mahogany and silicon bronze wood screws in the manner of other high quality boats from this company.

Construction is hard chine, batten seam construction above the chine and double planking below. Framing is white oak with 1" x 3" main frames and 1" x 1 1/4" intermediate frames. Floor timbers are 1 1/2" x 3" white oak. Chine logs are 3" x 2 3/4" white oak. The keel is white oak, 2" x 4" in dimension with 3/8" bronze keel bolts. Longitudinal framing is 1 3/4" fir. The cabin sides are beautiful varnished mahogany planks. Cabin tops are marine plywood and covered by traditional painted canvas or fiberglass overlay. The decking includes: fir planking over plywood in the cockpit; varnished mahogany side decking; and fiberglass over plywood on the foredeck.

Fuel tanks are Monel alloy.
Water tank is Monel alloy.
Holding tank is polyethylene.

The quality of materials used by skilled craftsmen is one of the reasons these Chris Craft vessels are long lived. This boat has been kept in a boathouse in fresh water which has protected the hull and exterior substantially over the years.

Waterline Boats / Boatshed does not independently verify capacities and measures, which are reported from seller-provided information and/or literature.

Forward Cabin (galley and head): An upholstered bench seat and pantry/storage area separates the chain locker from the galley. The galley is divided into port and starboard sections by centerline passageway/sole. Deep, varnished Honduras mahogany cabinets and pantry lockers with bright finished wood counters are located port and starboard. The starboard counter has an under-mount double stainless steel sink and routed grooves for draining dishes. Aft beneath the starboard counter is an electric refrigerator. To port is a two-burner alcohol cooktop. Furthest aft to port is the vessel’s single head with manual marine toilet, varnished Honduras mahogany vanity with raised marble sink. The head sole serves as a watertight shower pan for the hand held shower. There is a round escape hatch on centerline in overhead.

Pilothouse/Salon: Up and aft of the forward cabin is the main cabin containing the vessel’s single helm station and salon area. The helm station with original console is located to starboard with a wooden ships wheel, navigation equipment, engine instruments and controls. The helm seat is an upholstered bench which can seat two. The pilothouse paneling and trim are bright finished mahogany. There are two (2) large opening windows forward with original hardware. The port and starboard sides of the house are fitted with five (5) windows. One (1) window being installed in each of the two (2) cabin side entry doors. Two (2) windows per side are sliders. There are two (2) fixed, narrow windows across the aft end of the cabin. To port opposite the helm station the console top is continued. Aft to port is a large custom built “L” shaped settee with swinging, high – low drop leaf Honduras mahogany table. The settee and table can be converted to a large double berth. The convertible settee is fitted with upholstered cushions. The sole is carpeted and is fitted with two (2) sound insulated hatches for engine compartment access. Two (2) hinged wooden steps provide access to the side decks through the entry doors (P&S). The side entries are fitted with screen doors. Steps located in the aft starboard corner lead down to the aft cabin.

Engine Compartment and Forward Tank Space: Located forward beneath the main cabin/salon sole is the forward tank space which contains the hot water tank, pressurized water system components, MSD system holding tank and “Y” valve along with some ballast (starboard side). Aft of this space is the engine compartment which contains the single propulsion engine with reduction gear, house and start batteries, battery switches, battery charger and trim tab power panel. There is very good access for maintenance and repairs. Engine room ventilation is provided by natural draft intake through cowl vents at the cabin sides (P&S) and a 12V blower.

Aft (master) Stateroom: The aft cabin is laid out with a large queen-size berth to port. The removable bottom of the berth provides access to the aft half of the engine compartment. Built-in cabinetry and a hanging locker provide ample storage amidships. Steps in the starboard aft corner of the space lead up to a sliding varnished mahogany door and the aft cockpit. A hatch in the sole between the berths provides access to the propulsion shaft packing gland. Surfaces in the space are painted an off-white/cream color, including the exposed overhead. Some trim is varnished mahogany. The sole has been recently renewed with a dark tropical hardwood laminate over plywood. Large windows fitted with adjustable blinds are located port and starboard. Half of each window is a slider.

Two burner Origo 4100 non-pressurized alcohol stove;
Sunbeam Microwave oven;
Cuisinart Convection/toaster oven;
Waeco AC/DC refrigerator;
Double stainless steel sink;
AC electric space heaters;
Force 10 120 volt hot water heater, 11 gallons, with engine driven heating

2 feux(s) alcool cuisinière